Menu
Your Cart

ST-LINK V2 in-circuit debugger and programmer for STM8 and STM32

ST-LINK V2 in-circuit debugger and programmer for STM8 and STM32
ST-LINK V2 in-circuit debugger and programmer for STM8 and STM32
ST-LINK V2 in-circuit debugger and programmer for STM8 and STM32
-23 % Out Of Stock
ST-LINK V2 in-circuit debugger and programmer for STM8 and STM32
ST-LINK V2 in-circuit debugger and programmer for STM8 and STM32
ST-LINK V2 in-circuit debugger and programmer for STM8 and STM32

ST-LINK V2 in-circuit debugger and programmer for STM8 and STM32
₹1,149
₹1,499

(inc GST)

  • Stock: Out Of Stock
  • With this product you will receive ₹11 FlyRobo Cashback.
  • SKU: FR-07-520

The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board.

Much similar in architecture for debugging, the ST-LINK/V2 and the ST-LINK/V2-ISOL share the same features like digital isolation between the PC and the target application board which allows to withstands voltages of up to 1000 Vrms.

Specifically, the debugger incorporates the use of USB full-speed interface to communicate with the ST Visual Develop (STVD) or ST Visual Program (STVP) software for STM8 application, and use of the USB full-speed interface to communicate with Atollic®, IAR™, Keil®or TASKING integrated development environments for STM32 applications.

Features :

  • 1.65V to 5.5V application voltage supported on SWIM interface
  • 5V power supplied by a USB connector
  • USB 2.0 full speed compatible interface
  • 1.65V to 3.6V application voltage supported on the JTAG/SWD interface and 5V tolerant inputs
  • SWIM low speed and high-speed modes supported
  • USB standard A to mini B cable
  • Status LED which blinks during communication with the PC
  • Direct firmware update feature supported

Package Includes : 

1 x ST-LINK/V2 debugging and programming Unit.

1 x USB standard A to mini B cable.

1 x Connecting Cable for STM8 SWIM and STM32 JTAG/SWD protocol.

1 x Flat ribbon with a standard ERNI connector at one end.

Technical
Input Voltage

1.65 ~ 5.5 V

USB

USB A to Mini- B cable

Questions1 Answers1 | Expand All
When will delivered order?
Ajeet
  • Order will be delivered within 1-3 days in metro city, 3-5 days in other city and 4-7 days in villages or small city. This is the average time of delivery in express shipping. but can change with different locations and different situations.
    FlyRobo[ 16/07/2021 ]
    Was this answer helpful?34
Showing 1 to 1 of 1 (1 pages)

Write a review

Note: HTML is not translated!
Bad Good

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.

Name
Email
Phone
Comments