Specifications:With inner tyreDiameter: 68mmWidth: 26mmCentre hole: 5.3 x 3.66mm (two sides is semicircle)Weight: 50gNote:* Please allow 1-3CM differs due to manual measurement.* Due to the different display and different light, the picture may not reflect the actual color of the item. Thanks f..
Advance Metal Chassis 2 is powder coated Metal chassis for robots. Easy to mount the motors on the place by using normal motor mount nut. it is compatible with center Shaft Gear motor and BO Motor.This Chassis board is widely used as a mechanical frame structure of the mobile robots. It is the..
Advance Metal Chassis is powder coated Metal chassis for robots. Easy to mount the motors on the place by using normal motor mount nut.It can either be used in skid steel configuration (4 motors) or differential configuration (2 rear wheels + 1 front castor wheel). The body contains perforated holes..
It is used to connect a 9V battery to the application. This snap power cable to DC 9V clip male line battery adapter for mostly used to power Arduino boards.The connector comes with open wire at one end and battery connector at another end. It is very good practice to use such connector in the proje..
9V Battery Snap Connector to DC barrel jack adapter This connector is useful when you need to power some board using a 9V battery but that board has only a 2.1mm DC barrel jack to power it up. One can use this adapter to power up any DC barrel jack based power connector using a standard 9V batt..
Material: M. S. SteelThickness: 1 mmMotor Mounting Side: Height 25 mm and width 22 mmBracket Mounting Side: Height 12 mm and width 22 mmHole for Motor Mounting: 1-8mm diameterPackage included:1 x Motor Mounting Clamp..
Castor Wheel is omnidirectional wheel. which is generally use when Robot or car need to sharp turn.Specification:Base plate Dia. 34 mmCaster Wheel Dia. 21 mmWheel Height 24 mmMounting Hole Three, 120Â° apart, 3mm or 1/8 inch diameterPacking Content:1 x Caster Wheel BIGThis Castor Wheel Support ..
Castor Wheel is omnidirectional wheel. which is generally use when Robot or car need to sharp turn.Specification:Wheel Dia. 15 mmBall Dia. 13 mmPacking Content:1 x Caster Wheel SmallThis Castor Wheel Support Chassis : Advance Metal Chassis For Robots WhiteAdvance Metal Chassis Small Red..
This L Clamp bracket for Johnson Gear Motor is made up of 2mm thick Mild Steel which gives them excellent strength and stability. It has 13.5mm diameter holes for attaching the motor to the bracket and also 3mm diameter holes for mounting the bracket to the chassis or application. Features :Goo..
DPDT switch box in plastic for mounting 2 numbers of the rocker-type DPDT switches (Push To ON Type). This is Remote Control Box for Wired Robot. Remote Control Box is with the arrangement to mount two DPDT Switches. Switches are not included. The switch box is a combo of 2 switches compatible box u..
The DPDT Switch is generally used to make the Clockwise as well as the anti-clockwise motion of the motor. This switch is generally used for Polarity Reversal. It has momentary action where the switch can toggle to two poles on Press & Hold action and returns to the middle (OFF) position with it..