Brand: FlyRobo
SKU: 2570
IPEX to SMA Female External Adapter + SMA Male Antenna for 2.4G WIFI Module can be used for a wide array of wireless applications like point-to-point or point-to-multipoint architecture. The broadband characteristics of the antenna enable it to operate over a very wide frequency range with consisten..
₹73 ₹108
Brand: FlyRobo
SKU: 2139
L7812 is equipped with a heat sink, and a 3A rectifier bridge can meet high-current output. It uses a full-wave bridge rectifier, AC or DC can be entered, and the input regardless of positive and negative electrodes. Filtering using two large-capacity electrolytic capacitors 35V 220UF do buffer filt..
₹122 ₹138
Brand: FlyRobo
SKU: 265
This is an LM2596 DC-DC step-down converter with the high-precision potentiometer, capable of driving a load up to 3A with high efficiency, which can work with an Arduino nano, Arduino UNO, other mainboards and basic modules. When the output current keeps greater than 2.5A (or output power greater t..
₹48 ₹75
Brand: FlyRobo
SKU: 2101
Matrix Nand Programmer MTX SPI NAND Flasher V1.0 features a PIC18F2455 microcontroller for stable and quick reading/writing of all NAND models available on the different XBOX 360 models. It is also fully compatible with NAND PRO 2.0e and several other third-party programming tools.
Features:
..
₹701
Brand: FlyRobo
SKU: 1055
MCP4725 I2C DAC Breakout Development Board Module has MCP4725 which is an I2C controlled Digital-to-Analog converter (DAC). A very cost-efficient option of DAC allows you to send an analog signal, such as a sine wave, from a digital source, such as the I2C interface on the Arduino microcontroller. D..
₹113 ₹499
Brand: FlyRobo
SKU: 1035
Mega2560 Pro ATMEGA2560-16AU USB CH340G Development Board is based on the ATmega2560 microcontroller. Built on the Atmel ATmega2560 microcontroller and 16 MHz high-quality quartz resonators are present on the board. The board uses the chip CH340G as the converter UART-USB. It provides a stable data ..
₹1,148 ₹1,534
Brand: FlyRobo
SKU: 742
Micro SD Card Reader Module also called Micro SD Adaptor which is designed for dual I/O voltages. The Module is a simple solution for transferring data to and from a standard SD card. The pinout is directly compatible with Not only Arduino but can also be used with other microcontrollers.SD module h..
₹53 ₹78
Brand: FlyRobo
SKU: 790
The LilyTiny is a tiny little LilyPad board designed to add flashy functionality to your project without taking up a lot of room.
Even though it’s as small as some of the LilyPad sensors, this board actually has an ATtiny microcontroller on it so it’s actually pretty smart!
Simply sew on 4 L..
₹215
Brand: FlyRobo
SKU: 2862
The Micro:bit T-type GPIO Board is Here—Your Doorway to Endless Possibilities!
With our T-type GPIO Board, your Micro:bit can reach its full potential. This small, feature-rich expansion board is intended to give your Micro:bit projects a boost. This board will advance your inventions, whether yo..
₹165 ₹289
Brand: FlyRobo
SKU: 2174
MP2307 is a monolithic synchronous buck regulator. It integrates 100mΩ MOSFETS that provide 3A of continuous load current over a wide operating input voltage of 4.75V to 23V.
Features:
It has a wide 4.75V to 23V Operating Input Range.
Over-current protection
3A Continuous Output Current..
₹215 ₹269
Brand: FlyRobo
SKU: 2100
Naze32 F3 Blackbox Flash Recorder Module is a data logger that can record data on the memory card through the UART universal serial port. It can be used for flight control boards with cleanflight firmware and connected to the corresponding serial port.
Features:
Simple command-line interfac..
₹241 ₹589
Brand: FlyRobo
SKU: 706
PICKIT 3 In-Circuit Debugger/Programmer compatible to Microchip uses in-circuit debugging logic incorporated into each chip with Flash memory to provide a low-cost hardware debugger and programmer.
The PICKIT3 allows debugging and programming of PIC and dsPIC Flash microcontrollers using the powe..
₹1,655 ₹2,899
