Brand: FlyRobo
Model: FR-01-377
The LM393 Photosensitive LDR Sensor Module is a light detection module that uses an LDR (Light Dependent Resistor) to sense ambient light levels. It features an LM393 voltage comparator to provide a stable digital output signal when the light intensity crosses a set threshold. The module includes an..
₹27
Brand: FlyRobo
Model: FR-01-801
A compact but high-powered DC-DC step-up (boost) power supply converter module. The module features a wide operating supply range and a power supply input voltage between 3.5 to 35V that can step-up this input voltage from 4V to 35V.
The module includes an integrated voltage meter that can m..
₹410 ₹699
Brand: FlyRobo
Model: FR-07-300
This power supply is an automatic step-up/down power supply module. When the output voltage remains constant, the input voltage is equal to the bottom, up or the output voltage. For example, to set output as 12V, the input voltage between 5 ~ 32V output voltage is always 12V. It can achieve continuo..
₹631 ₹1,449
Brand: FlyRobo
Model: FR-01-992
RS422 interface, two-way communication. B Y Z A ultra far transmission 1000 meters. The module has ESD 15KV protection. Onboard to increase the limit of 10 ohms current limiting current protection. Module with TVS diode. Anti lightning, peak voltage. The module has 120-ohm termination resistors, whi..
₹97 ₹299
Brand: FlyRobo
Model: FR-01-955
Features:
1. Place it directly on a breadboard with red and blue lines.
2. With DC-005 round hole plug input, input voltage 6.5-12v, compatible with most power adapters.
3. With USB input, it can be directly connected to computer USB or 5V power supply.
4. With Micro USB input, most mobi..
₹60 ₹99
Brand: FlyRobo
Model: FR-01-803
This is MCP2515 CAN Bus Module with TJA1050 Transreceiver which can adopt CAN controller MCP2515 and TJA1050 high-speed CAN transceiver. Onboard independent key. Microchip MCP2515 independent CAN protocol controller, support CAN V2.0B regulation.
This is easy to use CAN bus module controlled via..
₹91 ₹379
Brand: FlyRobo
Model: FR-01-956
The Mini360 buck converter step down voltage regulator board is designed for use with RC airplanes, quadcopters, drones, RC cars, Arduino and other micro-controllers, and other DIY electronics needing an ultra-miniature, lightweight step-down voltage regulator.
It uses an integrally molded power ..
₹34 ₹84
Brand: FlyRobo
Model: FR-01-957
Features:
Special power module for breadboard, compatible with 5V and 3.3V.
Apply to the MB102 breadboard, very useful for Arduino breadboard projects.
DC 6.5-12V or USB power supply the input voltage.
The output voltage can be switched between 3.3V and 5V.
Two-way independent control ..
₹50 ₹69
Brand: FlyRobo
Model: FR-01-894
MT8870 DTMF Decoder Module is ideally suited to adding dual-tone multi-frequency (DTMF) decoding to your project. This detection module interprets the incoming tone and produces a coded output that can be connected to all manner of microcontrollers.
DTMF is commonly found in touch-tone devices su..
₹105 ₹147
Brand: FlyRobo
Model: FR-01-730
NE555 Frequency Adjustable Pulse generator Module utilizes the NE555 timer IC to generate pulses from about 4Hz to 1.3Khz. It generates a square wave signal used for experimental development or driving a stepper motor, it would be also a good choice for users learning& experiencing the analog RC cir..
₹48 ₹83
Brand: FlyRobo
Model: FR-01-550
The Non-Destructive MP3 Decoding Board with Self-Powered TF Card U Disk Decoded Player module is used for playing tracks in the MP3 format stored on a micro SD card or USB memory. Onboard 2W mono amplifier is connected to the speaker, 3.5mm gold plated headphone jack can connect with headphones or e..
₹110 ₹190
Brand: FlyRobo
Model: FR-01-747
PAM8403 5V Two-Channel Stereo Audio Amplifier Module is based on PAM8403 which is a 3W+3W, class-D audio amplifier. Allowing it to achieve high-quality sound reproduction. The new filterless architecture allows the device to drive the speaker directly, requiring no low-pass output filters, thus savi..
₹19 ₹67