Menu
Your Cart

Development Board and Accessories

Brand: FlyRobo Model: FR-01-825
This is a 10K ohm Negative Temperature Coefficient (NTC) thermistor. NTC Thermistor is one of the most commonly used temperature sensors. In an NTC the resistance value decreases as the temperature increases.NTC 10K can be applied to air conditioner devices, heating devices, clinical thermometer, au..
₹14
10K Sliding Adjustable Potentiometer Module - Flyrobo.in
-20 %
Brand: FlyRobo Model: FR-01-972
Sliding Adjustable Potentiometer Module 10k is an electronic slider potentiometer module which is adjustable or compatible with Arduino / Raspberry Pi for all your DIY needs. This is a sliding type potentiometer whose resistance can adjustable with the help of the slider switch.   Features: ..
₹199 ₹249
10KG Load Cell Mini Weight Sensor
-15 %
Brand: FlyRobo Model: FR-01-576
This load cell (sometimes called a pressure gauge) can translate up to 10kg of stress (force) into an electric signal. Each load cell can measure the electrical resistance that changes in response to, and proportionality of, the strain (e.g. pressure or force) applied to the pub. With this gauge, ..
₹279 ₹329
Brand: FlyRobo Model: FR-01-761
The Keypad 4x3 features a total of 12 buttons in Matrix form. This is a membrane keypad with no moving parts. A female 7-pin berg connector is provided for interfacing it with your microcontroller circuits. Convenient adhesive backing provides a simple way to mount the keypad in a variety of applica..
₹89 ₹95
Brand: FlyRobo Model: FR-06-602
12 V 4010 Cooling Fan is a small but powerful fan. It maintains the temperature of the extruder, which results in good heat dispersion and wonderful performance.  The cooling fan operates on a 12V DC power supply which can be easily powered from the RPI board. It has a 2 pin connector to easily c..
₹99
12 V 6010 0.15A Cooling Fan
Out Of Stock
Brand: FlyRobo Model: FR-06-601
12 V 6010 Cooling Fan is a small but powerful fan. It maintains the temperature of the extruder, which results in good heat dispersion and wonderful performance. The cooling fan operates on a 12V DC power supply which can be easily powered from the RPI board. It has a 2 pin connector to easily ..
₹99
12-40V 10A DC Motor PWM Speed Controller Board Module
Out Of Stock
Brand: FlyRobo Model: FR-01-722
High Power DC Motor Speed Controller lets you control the speed of a DC motor using a Pulse Width-Modulated (PWM) DC voltage with a Duty Cycle fully adjustable from 10%-100%. It can be used to drive all DC Brushed Motors that work between 12V-40V DC and consume up to 10A of current.Features:Control ..
₹238
12864B V2.0 Graphic Blue Color Backlight LCD Display Module
Out Of Stock
Brand: FlyRobo Model: FR-01-673
The 12864B V2.0 is based on the ST7920 controller, which is commonly used for Arduino.This display works on SPI. It is easy to use and compatible with the majority of microcontrollers out there. You can do a lot of graphics stuff with this display. You can create frames and even make small animation..
₹589
12Bit WS2812 5050 RGB LED Built-in Full Color Driving Lights Circular Development Board
Out Of Stock
Brand: FlyRobo Model: FR-01-649
This is the 12 LED ring, a small chainable 85mm outer diameter board equipped with 5050 WS2812 RGB LEDs. The WS2812s are each addressable. The driver chip is located inside the LED. Each Stick has ~18mA constant current drive so the color will be very consistent even if the voltage varies, and requi..
₹249
12mm Photosensitive LDR Sensor
Out Of Stock
Brand: FlyRobo Model: FR-01-515
If you need a way to sense the level of ambient light then there is no easier way to do it without an LDR/photo-resistor. The resistance of Light Sensitive Photoresistor LDR changes with the change in the ambient light exposure on the surface of the sensor. Light Dependent Resistor is a type of phot..
₹35
Brand: FlyRobo Model: FR-01-853
This is a 12V 16 Channel Relay Module with Light Coupling LM2576 Power Supply, Be able to control various appliances and other equipment with a large current. It can be controlled directly by Micro-controller (Arduino, 8051, AVR, PIC, DSP, ARM, MSP430, TTL logic).This is a 12V 16-Channel Relay inter..
₹739
Brand: FlyRobo Model: FR-06-604
12V 3010 Cooling Fan is a small but powerful fan. It maintains the temperature of the extruder, which results in good heat dispersion and wonderful performance.  The cooling fan operates on a 12V DC power supply which can be easily powered from the RPI board. It has a 2 pin connector to easily co..
₹99
Showing 73 to 84 of 700 (59 Pages)

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.

Name
Email
Phone
Comments